Effect on Rotation Speed on Thermal Dehydration Characteristics of Waste Gypsum Particles in a Constant Volume Rotary...

This study examined the thermal dehydration characteristics of CaSO₄∙2H₂O in a constant-volume rotary vessel. The experiment used CaSO₄∙2H₂O particles obtained from the crushed waste gypsum board. The particle size ranged from 850 to 2000 μm, and the experiment was carried out at varying rotation speeds of 1, 10, and 35 rpm, with the vessel temperature heated to 180 °C. Temperature and pressure inside the vessel were measured simultaneously using the thermocouple and the pressure sensor. The XRPD measurement analyzed the transition of CaSO₄∙2H₂O after the heating of particles. The result showed that the temperature growth rate was similar for high rotation speeds of 10 and 35 rpm, while periodic temperature changes occurred at the low rotation speed of 1 rpm. A distinguishing flow pattern was observed at the low rotation speed, and the particles inside the vessel collapsed periodically downward. This particle behavior was related to the temperature distribution of the rotation speed of 1 rpm. Additionally, the pressure in the vessel increased rapidly at higher rotation speeds. This trend indicates the desorption of the crystal water of CaSO₄∙2H₂O due to the increasing temperature in the case of high rotation speed. Also, the XRPD measurement results showed the appearance of CaSO₄∙0.5H₂O under the higher rotation speed conditions, and the mass fraction of CaSO₄∙0.5H₂O increased with the rotation speed. Overall, the present study suggests that rotation speed plays a crucial role in determining the heat conduction and heat transfer of particles in a constant-volume rotary vessel.