Related Experiment Video
Updated: Jun 29, 2025

Techniques for the Evolution of Robust Pentose-fermenting Yeast for Bioconversion of Lignocellulose to Ethanol
Published on: October 24, 2016
Ethanol and Higher Alcohols' Production in Fungal and Bacterial Laboratory Cultures and Significance for Forensic
Vassiliki A Boumba1, Glykeria Velivasi1, Nikolaos Kourkoumelis2
1Departments of Forensic Medicine & Toxicology, Faculty of Medicine, School of Health Sciences, University of Ioannina, 45500 Ioannina, Greece.
Abstract:
Ethanol can be produced by many microorganisms that colonize a dead body. Ethanol's concentration depends on the congener higher alcohols, 1-propanol, isobutanol, 2-methyl-1-butanol, 3-methyl-1-butanol, and 1-butanol, as previous research has shown. This correlation is expressed by mathematical models which estimate the concentration of microbial ethanol. The aim of this contribution was to study the ethanol and higher alcohols' production in various laboratory bacterial and fungal cultures and the applicability of the bacterial and fungal models (which concern the bacteria E. coli, S. aureus, K. pneumoniae, and E. faecalis, and the fungus C. albicans) in these samples, as well as in blood samples from autopsy cases, with the overall objective of investigating the models' applicability in routine casework. The bacteria and fungus were cultured in conventional culture media and in denatured human blood cultures under various conditions. The alcohols' concentrations were determined using a head space-gas chromatography-flame ionization detector (HS-GC-FID). The previously reported bacterial and yeast models were applied in the cultured samples and in blood from 122 autopsy cases. Our results showed that 1-propanol was not produced by C. albicans and E. faecalis under certain conditions. Also, 1-butanol was not produced by C. albicans, E. faecalis, and K. pneumonia under certain conditions. Furthermore, the bacterial models were applicable in postmortem samples irrespective of the microbes that were possibly activated in the sample, while the EC models showed the best applicability among all the bacterial and yeast models. The best applicability of the bacterial models was observed in autopsy blood with 0.10 g/L < BAC < 1.0 g/L in cases of violent and undetermined causes of death and in cases with putrefaction. Finally, the yeast models were applicable in limited, possibly special, autopsy cases. In conclusion, it could be inferred that the source of ethanol in any given postmortem blood sample is likely microbial if either most bacterial models or at least one model from each distinct bacterial species is successfully applicable.
More Related Videos
16:33Methods for Facilitating Microbial Growth on Pulp Mill Waste Streams and Characterization of the Biodegradation Potential of Cultured Microbes
Published on: December 12, 2013
06:53Isolation, Characterization, and Total DNA Extraction to Identify Endophytic Fungi in Mycoheterotrophic Plants
Published on: May 5, 2023
Related Concept Videos
Physical Properties of Alcohols and Phenols
Alcohols possess a higher boiling point than aliphatic hydrocarbons of...
Fates of Pyruvate
In aerobic organisms, pyruvate is metabolized via the citric acid cycle to produce reduced coenzymes NADH and FADH2. These coenzymes are then oxidized in the electron transport chain to produce ATP and, in the process, regenerate the NAD+ and FAD. As seen in some cell types and organisms, fermentation...
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
Fermentation
Fermentation is a type of metabolic process that occurs in the absence of oxygen, where organic molecules such as glucose are broken down to produce energy. During this process, the...
Mass Spectrometry: Alcohol Fragmentation
Preparation of Alcohols via Addition Reactions
The acid-catalyzed addition of water to the double bond of alkenes is a large-scale industrial method used to synthesize low-molecular-weight alcohols. An acidic atmosphere is required to allow the hydrogen in the water molecule to act as an electrophile and attack the double bond in an alkene. The addition of a proton to the double bond creates a carbocation intermediate. The proton preferentially bonds to the less substituted end of the double bond to create a more stable carbocation...