External training load and performance recovery after small-sided games in soccer: Insights for return-to-play...

The return-to-play process' characteristics can vary by injury and sport type but are typically composed of phases of different durations, training targets, and intensities that gradually increase the physiological and mechanical load. In team sports, contact drills are a necessary part of the last phases of this process, and they should be planned using the optimal mechanical load. The present study investigated the external load and kinetic recovery in U19 soccer players performing 6vs6 and 3vs3 small-sided games. A global positioning system (GPS) measured external load metrics. The rate of perceived exertion (RPE) was registered at the end. Total quality of recovery (TQR) was collected at the beginning of the training session and after 24 h. Moreover, before and after the small-sided games (SSGs) and at 24 h, delayed-onset muscle soreness (DOMS) of the legs, sprinting time, and vertical jump height (CMJ) were collected. 6vs6 presented higher values in total distance low-, moderate-, high, and very-high-speed distance, and maximum speed (p < 0.05). However, 3vs3 showed higher number of sprints, acceleration, and deceleration at different intensities. Furthermore, no difference was shown in RPE. The effect of fatigue on sprint seems greater for 6vs6, showing an impairment persistent at 24 h (p < 0.05). Moreover, CMJ height was impaired after 6vs6 and at 24 h (p < 0.05) but did not change after 3vs3 (p > 0.05). DOMS values after SSGs and at 24 h were higher than baseline for both conditions (p < 0.05), while TQR decreased at 24 h in both conditions (p < 0.05). Based on our results, it seems that 6vs6, leading to a greater high-speed running distance, might cause a training load that needs more time to recover. This point may be crucial in a return-to-play process, especially when hamstring muscles are involved.