Simulated Hydrostatic Pulpal Pressure Effect on Microleakage-An Initial Study

This study's purpose was to evaluate the effect of simulated in vitro hydrostatic pulpal pressure (HPP) on microleakage.

Extracted third molars (n=12) were sectioned 5 mm below the cementoenamel junction, pulp tissue removed, and the sectioned crowns mounted on a Plexiglas plate penetrated by an 18-gauge stainless steel tube. The mounted specimen mesial surface received a 2×4×6 mm Class V preparation followed by restoration with a strongly acidic, one-step dental adhesive and a flowable microfilled resin, following all manufacturers' instructions. Restorations were finished to contour, and tubing was attached to a 20-cm elevated, 0.2% rhodamine G reservoir to the specimen steel tube for 48 hours. Specimens then received a nail polish coating to within 1 mm of the restoration margins and were placed in 2% methylene blue (MB) dye for 24 hours, followed by rinsing, embedding in epoxy resin, and sectioning into 1 mm slices using a diamond saw. Controls were intact molars (n=12) processed as above but without HPP. Specimen slices were evaluated using laser confocal microscopy with images exported to ImageJ software with microleakage assessed as the MB linear penetration as a percentage of the total interfacial wall length. Mean values were evaluated with the Kruskal Wallis/Dunn test at a 95% confidence level.

The control specimens demonstrated significantly greater (p<0.0001) MB penetration than experimental specimens with simulated HPP. Under this study's conditions, simulated HPP significantly decreased MB dye penetration.

Studies accomplished without simulated HPP may overestimate microleakage results.