Related Experiment Video
Updated: Jun 28, 2025
Synthesis and Performance Characterizations of Transition Metal Single Atom Catalyst for Electrochemical CO2 Reduction
Published on: April 10, 2018
Global Vision of the Reaction and Deactivation Routes in the Ethanol Steam Reforming on a Catalyst Derived from a
Sergio Iglesias-Vázquez1, José Valecillos1, Aingeru Remiro1
1Department of Chemical Engineering, University of the Basque Country (UPV/EHU), P.O. Box 644, Bilbao 48080, Spain.
Abstract:
Ethanol steam reforming (ESR) over a Ni/Al2O3 catalyst prepared by reduction of a NiAl2O4 spinel is a promising alternative route to produce H2 from biomass. This work deepens into the effect of reaction conditions (450-650 °C, a steam/ethanol (S/E) ratio of 3-9, and a weight space time up to 1.3 h) and evaluates the time on stream evolution of the yields of H2, gaseous byproducts (CO, CO2, CH4, C2H4, C2H4O), and formed carbon/coke. The results are explained taking into consideration the thermodynamics, the extent of each individual reaction, and the catalyst deactivation. Up to 600 °C, the predominant intermediate in the H2 formation is C2H4 (formed by ethanol dehydration) with the preferential formation of nanostructured carbon (nanotubes/filaments) by C2H4 decomposition. The deposition of this type of carbon partially deactivates the catalyst, mainly affecting the extent of the C2H4 decomposition causing a sharp decrease in the H2 and carbon yields. Nevertheless, the catalyst reaches a pseudosteady state with an apparent constant activity for other reactions in the kinetic scheme. At 650 °C, C2H4O (formed by the ethanol dehydrogenation) is the main intermediate in the H2 formation, which is the precursor of an amorphous/turbostratic carbon (coke) formation that initially causes a rapid deactivation of the catalyst, affecting the ethanol dehydration and, to a lower extent, the reforming and water gas shift reactions. The increase in the S/E ratio favors the H2 formation, attenuates the catalyst deactivation due to the suppression of the ethanol dehydration to C2H4, and promotes the reforming, water gas shift, and carbon/coke gasification reactions. A H2 yield of 85% stable for 48 h on stream is achieved at 600 °C, with a space time of 0.1 h and an S/E ratio of 9.
Related Concept Videos
02:24Reduction of Alkynes to cis-Alkenes: Catalytic Hydrogenation
Like alkenes, alkynes can be reduced to alkanes in the presence of transition metal catalysts such as Pt, Pd, or Ni. The reaction involves two sequential syn additions of hydrogen via a cis-alkene intermediate.
02:50Catalysis
02:17Reduction of Alkenes: Asymmetric Catalytic Hydrogenation
The metal catalyst used can be either heterogeneous or homogeneous. When hydrogenation of an alkene generates a chiral center, a pair of enantiomeric products is expected to form. However, an enantiomeric excess of one of the products can be facilitated using an enantioselective reaction or an...
02:23Alcohols from Carbonyl Compounds: Reduction
Catalytic hydrogenation is similar to the reduction of an alkene or alkyne by adding H2 across the pi bond in the presence of transition metal catalysts like Raney Ni, Pd–C, Pt, or Ru. Aldehydes and ketones can be reduced by this method, often under mild to moderate heat (25–100°C) and...
02:13Reduction of Alkenes: Catalytic Hydrogenation
Metals like palladium, platinum, and nickel are commonly used in their solid forms — fine powder on an inert surface. As these catalysts remain insoluble in the reaction mixture, they are referred to as heterogeneous catalysts.
The hydrogenation process takes place on the...
02:17Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule
The hydrohalogenation of an unsymmetrical alkene can yield two haloalkane products, depending on which vinylic carbon takes up the halogen. However, one product usually predominates, where hydrogen adds to the vinylic carbon bearing the...