Estimating airborne trichloramine levels in indoor swimming pools using the well-mixed box model

Exposure to airborne disinfection by-products, especially trichloramine (TCA), could cause various occupational health effects in indoor swimming pools. However, TCA concentration measurements involve specialized analysis conducted in specific laboratories, which can result in significant costs and time constraints. As an alternative, modeling techniques for estimating exposures are promising in addressing these challenges. This study aims to predict airborne TCA concentrations in indoor swimming pools using a mathematical model, the well-mixed box model, found in the IHMOD tool, freely available on the American Industrial Hygiene Association website. The model's predictions are compared with TCA concentrations measured during various bather load scenarios. The research involved conducting 2-hr successive workplace measurements over 16- to 18-hr periods in four indoor swimming pools in Quebec, Canada. TCA concentrations were estimated using the well-mixed box model, assuming a homogeneous mixing of air within the swimming pool environment. A novel approach was developed to estimate the TCA generation rate from swimming pool water, incorporating the number of swimmers in the model. Average measured concentrations of TCA were 0.24, 0.26, 0.14, and 0.34 mg/m³ for swimming pools 1, 2, 3, and 4, respectively. The ratio of these measured average concentrations to their corresponding predicted values ranged from 0.51 to 1.30, 0.67 to 1.04, 0.57 to 1.14, and 0.68 to 1.49 for the respective swimming pools. In a worst-case scenario simulating the swimming pool at full capacity (maximum bathers allowed), TCA concentrations were estimated as 0.23, 0.36, 0.14, and 0.37 mg/m³ for swimming pools 1, 2, 3, and 4. Recalculated concentrations by adjusting the number of swimmers so as not to exceed the recommended occupational limit concentration of 0.35 mg/m³ gives a maximum number of swimmers of 63 and 335 instead of currently 80 and 424 for swimming pools 2 and 4, respectively. Similarly, for swimming pools 1 and 3, the maximum number of swimmers could be 173 and 398 (instead of the current 160 and 225, respectively). These results demonstrated that the model could be used to estimate and anticipate airborne TCA levels in indoor swimming pools across various scenarios.