Raman silent region - based method for detection of pesticides with cyano group

Based on the fact that not all chemical substances possess good Raman signals, this article focuses on the Raman silent region signals of pesticides with cyano group. Under the optimized conditions of methanol-water (1:1, v/v) as the solvent, irradiation at 302 nm light source for 20 min, and the use of 0.5 mol/L KI as the aggregating agent, Surface-enhanced Raman spectroscopy (SERS) method for azoxystrobin detection was developed by the Raman silent region signal of 2230 cm^-1, and verified by detecting the spiked grapes with different concentrations of azoxystrobin. Other four pesticides with cyano group also could be identified at the peak of 2180 cm^-1, 2205 cm^-1, 2125 cm^-1, and 2130 cm^-1 for acetamiprid, phoxim, thiacloprid and cymoxanil, respectively. When azoxystrobin or acetamiprid was mixed respectively with chlorpyrifos without cyano group, their SERS signals in the Raman silent region of chlorpyrifos were not interfered, while mixed with cymoxanil in different ratios (1:4, 1:1 and 4:1), respectively, each two pesticides with cyano group could be distinguished by the changes in the Raman silent region. In further, four pesticides with or without cyano group were mixed together in 1:1:1:1 (acetamiprid, cymoxanil, azoxystrobin chlorpyrifos), and each pesticide still could be identified even at 0.5 mg/L. The results showed that the SERS method combined with UV irradiation may provide a new way to monitor the pesticides with C≡N performance in the Raman silent region without interference from the food matrix.