Fatigue Crack Growth Rates and Crack Tip Opening Loads in CT Specimens Made of SDSS and Manufactured Using WAAM

Additive manufacturing offers greater flexibility in the design and fabrication of structural components with complex shapes. However, the use of additively manufactured parts for load-bearing structural applications, specifically involving cyclic loading, requires a thorough investigation of material fatigue properties. These properties can be affected by many factors, including residual stresses and crack tip shielding mechanisms, which can be very different from those of conventionally manufactured materials. This research focuses on super duplex stainless steels (SDSSs) fabricated with wire arc additive manufacturing (WAAM) and investigates their fatigue crack growth rates and the net effect of crack tip shielding mechanisms. Using the compliance-based method, we measured crack tip opening loads in compact tension (CT) specimens with cracks propagating longitudinally and transversely to the WAAM deposition direction. It was found that fatigue crack growth rates were very similar in both directions when correlated by the effective stress intensity factor range. However, the differences in crack tip opening loads explain a quite significant influence of the deposition direction on the fatigue life.