Thermal Effects on Dental Pulp during Laser-Assisted Bleaching Procedures with Diode Lasers in a Clinical Study

Background In the current cosmetics industry, bleaching is often associated with lasers. However, such treatment also harbors risks. Tooth death is observed at pulpal temperature increases ≥5.6 °C. Therefore, it seems important to investigate the effects of using different lasers. The aim of this study was to determine pulpal temperature increases at different laser parameters during bleaching by modeling a realistic environment and to compare the temperature recording using a thermocouple and thermal camera. The authors assumed that there are laser settings for the lasers used at which the pulpal temperature increases are <5.6 °C and that the temperature recordings with thermocouples and thermal cameras differ only minimally. Methods Human teeth were used, which were extracted for dental reasons. During experiment, teeth were bleached conventionally and by laser activation at 940 nm, 445 nm, and 970 nm. The temperature in the pulp was recorded using thermocouples. In a second setup, longitudinally halved teeth were bleached, while the temperature in the pulp was recorded with a thermocouple and thermal camera. Descriptive statistics were used. The significance level is 0.05. Results In addition to conventional bleaching, temperature increases <5.6 °C were observed for bleaching at 940 nm 1.5 W, at 445 nm 0.3 W, and at 970 nm 0.5 W. For bleaching procedures using 940 nm 7 W, 940 nm 2 W, 445 nm 0.5 W, and 970 nm 1 W, the temperature increase was ≥5.6 °C. Significant differences (p < 0.05) were found in the maximum temperature increases (°C) between all groups. Temperature recordings using a thermocouple and thermal camera differed by about 2.3 °C. The working hypotheses were confirmed. Conclusion With laser bleaching, attention must be paid to the type of laser, its power, and the time in order to avoid excessive overheating of the dental pulp.