Related Experiment Video
Updated: Jun 20, 2026
In situ Compressive Loading and Correlative Noninvasive Imaging of the Bone-periodontal Ligament-tooth Fibrous Joint
Published on: March 7, 2014
Root canal conicity determination of primary second molars using nanotomography: An in vitro study
Marília Pacífico Lucisano1, Gilmer Torres Ramos1,2, Daniel José Blanco-Victorio3
1Department of Pediatric Dentistry, School of Dentistry of Ribeirão Preto, University of São Paulo, Ribeirão Preto, São Paulo, Brazil.
Background:
The conicity of the root canals of primary teeth is an important measure for endodontic therapies. However, determining this conicity depends on the methods employed, which requires further investigation.
Aim:
The aim of this study was to determine the conicity of the root canals of the upper and lower primary second molars using nanotomography (nCT).
Design:
An in vitro study was performed using nine primary second molars, both upper and lower, subjected to nCT. Comparisons between the diameters of root canals were performed between the thirds (cervical-D0, middle-D5, and apical-D7). The conicity (%) was determined for each root canal from cervical to apical. Data were statistically analyzed with a significance level of 5%.
Results:
The conicity ranged from 2% to 8% for the upper primary second molars. Significant differences in root canal diameter between the thirds (D0, D5, and D7 points) were observed in the mesio- and distobuccal roots (p < .05), but not in the palatal roots (p > .05). For the lower primary second molars, the conicity ranged from 2% to 17%, as well as significant differences in root canal diameter between the thirds (D0, D5, and D7 points) were observed in all roots (distal, mesiobuccal, and mesiolingual; p < .05).
Conclusion:
The conicity of the upper primary second molars was different from that of the lower ones, which showed a greater variability.
