Reducing Calcium Dissolution in Tunnel Shotcrete: The Impact of Admixtures on Shotcrete Performance

Groundwater infiltration into tunnels causes water to percolate through the fissure channels in the initial support shotcrete. This results in the dissolution and outflow of calcium hydroxide, a key product of cement hydration. This process significantly incurs the formation of crystallization blockages in the tunnel drainage systems. Optimizing the shotcrete mixing ratio is a feasible way to mitigate these blockages. Therefore, this study conducts calcium dissolution tests to investigate the impact of six admixtures, namely, antialkali agent, nanosilica, nanosilica carbonate, fly ash, sodium methyl silicate waterproofing agents, and silane waterproofing agents, on calcium dissolution resistance. Also, mechanical and microscopic tests are carried out to examine their impact on the strength and pore structure of the shotcrete. The objective of this study is to determine the optimal admixture for enhancing the calcium dissolution resistance of shotcrete. Results indicate that the antialkali agent significantly reduces the calcium leaching content of shotcrete. When the dosage is 14%, the calcium leaching amount is reduced by 68.4% in 28 days. Followed by nanosilica and silane waterproofing agents, with optimal dosages of 12 and 0.4%, respectively, the dissolution amount of calcium ions in shotcrete was reduced by 32.87 and 26.5%, respectively. Fly ash curing for 28 days can also reduce the calcium ion dissolution of shotcrete, while nanocalcium carbonate and sodium methyl silicate have little effect on the calcium dissolution of shotcrete. The antialkali agent with a strong calcium ion dissolution effect can improve the tensile strength of shotcrete under long-term curing conditions, which can be increased by 52%, but it compromises the growth of compressive strength. Nanosilica, fly ash, and silane waterproofing agents can improve both the compressive strength and tensile strength of shotcrete under long-term curing conditions. Specifically, at 28 days of curing, the compressive strength increased by 16.83, 28.8, and 20% and the tensile strength increased by 50.24, 60, and 64.5%. In addition, the microscopy results show that the antialkali agent, nanosilica, and silane waterproofing agents promote the hydration process of cement to form ettringite with a low and stable calcium-silicon ratio and reduce calcium hydroxide crystals. Nanosilica and silane waterproofing agents optimize the pore distribution in shotcrete by increasing beneficial pores, decreasing harmful pores, and reducing total porosity.