Related Experiment Video
Updated: Jun 27, 2025

Determining Tribocorrosion Rate and Wear-Corrosion Synergy of Bulk and Thin Film Aluminum Alloys
Published on: September 11, 2018
Effect of wear on the dynamic characteristics of a rigid rotor supported by journal bearings
Logamurthi Raja Moorthi1,2, Jawaid Iqbal Inayat-Hussain3,4, Azrul Abidin Zakaria5,6
1College of Graduate Studies, Universiti Tenaga Nasional, Jalan IKRAM-UNITEN, 43000, Kajang, Selangor, Malaysia.
Abstract:
The purpose of this work is to examine the effects of wear severity on the static and dynamic characteristics of journal bearings, and on the vibration response of a rigid rotor supported by journal bearings. Numerical simulations using MATLAB was conducted for three different operating regimes, namely low loaded operating regime ( ), moderately loaded operating regime ( ) and highly loaded operating regime ( ) with wear depth parameter ratio ( ) varied from 0 to 0.5 at increments of 0.1. Numerical results showed that the vibration response of the rotor generally increases with the increase of the wear depth for all cases of low, moderately and highly loaded operating regimes of the bearings. For the values of parameters considered in this work, it was shown that the vibration response amplitude of the rotor in worn journal bearings may be six times larger compared to the response amplitude of the rotor in non-worn bearings.
Related Concept Videos
Journal Bearings
To better understand the concept of journal bearings, consider a rope winch with dry or...
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular...
Bearing Stress
Due to the intricacy of these microforces, an average value, known as bearing stress, is often used by...
Residual Stresses in Circular Shafts
Pivot Bearings
A pivot bearing is a specialized type of bearing designed to support axial loads on a rotating shaft. The bearing surface, or the pivot, is positioned at the end of a shaft to support the axial thrust. The pivot may...
Bearings: Problem Solving

