Effect of liming on polycyclic aromatic hydrocarbons leaching from hydrocarbon-contaminated tectogenic industriosol

Soil stabilization/solidification is commonly employed remediation method for contaminated soils. Until now, limited attention has been given to the application of quicklime in polycyclic aromatic hydrocarbons (PAHs) contaminated soil. We treated a tectogenic industriosol spiked with 50 mg kg^-1 of four PAHs (12.5 mg kg^-1 each of fluorene (FLU), phenanthrene (PHE), fluoranthene (FLT) and pyrene (PYR)) using three different liming agents at 1% (w:w): quicklime (CaO), hydrated lime (Ca(OH)₂) and carbonate calcium (CaCO₃). All treated samples were leached in water at a solid-liquid ratio of 10, with subsequent analysis of leached soil and leachates for PAHs content. Results revealed that the addition of liming agents led to a reduction in FLU and PHE concentrations in treated soil by 6.81 ± 2.47% and 28.88 ± 4.18%, respectively, compared to a not-treated sol. However, no significant impact was observed on the 4-cycles PAHs (FLT and PYR). The addition of liming agents also significantly decreased the amount of PAHs in the leachate, by 100% for FLU and PHE, and by 74.9 ± 17.5% and 72.3 ± 34.8%, for FLT and PYR, respectively, compared to not limed soil. Among the liming agents, quicklime was the most effective in reducing the amount of 4 cycles PAHs in the leachate. Various mechanisms, such as encapsulation, volatilization and oxidation could contribute to this observed reduction. Quicklime treatment at a concentration of 1% w:w in PAHs-contaminated soil emerges as a promising technique to effectively reduce PAHs concentration in soils and mitigate PAHs mobility through leaching. This study also sheds light on the possibility to limit CO₂ emissions and resources exploitation to assure the remediation process, thereby enhancing its overall environmental sustainability.