Research on trajectory control technology for L-shaped horizontal exploration wells in coalbed methane

Horizontal wells have significant advantages in coal bed methane exploration and development blocks. However, its application in new exploration and development blocks could be challenging. Limited geological data, uncertain geological conditions, and the emergence of micro-faults in pre-drilled target coal seams make it hard to accurately control the well trajectory. The well trajectory prior to drilling needs to be optimized to ensure that the drilling trajectory is within the target coal seam and to prevent any reduction in drilling ratio (defined here as the percentage of the drilling trajectory in the entire horizontal section of the well located in the target coal seam) caused by faults. In this study, the well trajectory optimization is achieved by implementing the following process to drill pilot hole, acquire 2D resonance, and azimuthal gamma logging while drilling. The pilot hole drilling can obtain the characteristic parameters of the target coal seam and the top and bottom rock layers in advance, which can provide judgment values for the landing site design and real-time monitoring of whether the wellbore trajectory extends along the target coal seam; 2D resonance exploration can obtain the construction of set orientation before drilling and the development of small faults and formation fluctuations in the horizontal section, which can optimize the well trajectory in advance; the azimuth gamma logging while drilling technology can monitor the layers drilled by the current drill bit in real time, and can provide timely and accurate well trajectory adjustment methods.The horizontal well-Q in the Block-W of the Qinshui Basin was taken as a case study and underwent technical mechanism research and applicability analysis. The implementation of this new innovative process resulted in a successful drilling of a 711 m horizontal section, with a target coal seam drilling rate of 80%. Compared to previous L-type wells, the drilling rate increased by about 20%, and the drilling cycle shortened by 25%. The technical experience gained from this successful case provides valuable insight for low-cost exploration and development of new coalbed methane blocks.