Differences in knee flexor and extensor force and kinematic variables in rural versus urban area female students in

Ioana Mădălina Petre1, Hadi Nobari2,3, Mircea Boscoianu1

  • 1Department of Industrial Engineering and Management, Transilvania University of Brasov, Brasov, Romania.

PubMed

Related Concept Videos

Static Equilibrium - II01:07

Static Equilibrium - II

Static equilibrium is a special case in mechanics that is very important in everyday life. It occurs when the net force and the net torque on an object or system are both zero. This means that both the linear and angular accelerations are zero. Thus, the object is at rest, or its center of mass is moving at a constant velocity. However, this does not mean that no forces are acting on the object within the system. In fact, there are very few scenarios on Earth in which no forces are acting upon...
Strain and Elastic Modulus01:15

Strain and Elastic Modulus

The quantity that describes the deformation of a body under stress is known as strain. Strain is given as a fractional change in either length, volume, or geometry under tensile, volume (also known as bulk), or shear stress, respectively, and is a dimensionless quantity. The strain experienced by a body under tensile or compressive stress is called tensile or compressive strain, respectively. In contrast, the strain experienced under bulk stress and shear stress is known as volume and shear...
Equivalent Couples01:28

Equivalent Couples

In mechanical engineering, the concept of equivalent couples plays a crucial role in understanding and analyzing various mechanical systems.
Two couples are considered to be equivalent if they produce the same rotational effect on a rigid body. In other words, the two couples have the same magnitude and act in the same direction, causing the same angular displacement or acceleration in the body.
For instance, consider two couples lying in the plane of the page, with one having a pair of equal...
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added together...
Measurements of Strain01:27

Measurements of Strain

Strain quantifies the deformation of a material under force, typically measured as normal strain, which represents the change in length when compared with the original length. Electrical strain gauges are used for enhanced accuracy. These devices consist of a conductive wire mounted on a paper backing that adheres to the material's surface. These gauges operate on the piezoresistive effect, where the wire's electrical resistance changes in response to mechanical deformation. The strain gauge...
Logarithmic Differentiation01:28

Logarithmic Differentiation

When a car’s weight and driving forces act on a tire, they impose an external load on the rubber material. This load is resisted internally by forces distributed throughout the tire structure, which are defined as stress. The resulting deformation of the rubber due to this stress is quantified as strain. The relationship between stress and strain governs how the tire deforms under load and is central to understanding its mechanical response during operation.Rubber exhibits a nonlinear...