Crystallisation Dynamics in Large-Scale Extrusion Additive Manufacturing: An Analysis with and without Temperature...

Large-Scale Material Extrusion (LS-MEX) is increasingly being used in small-scale production and prototyping due to its ability to create components in new temporal and spatial dimensions. However, the use of this manufacturing process poses microscopic and macroscopic challenges not encountered in previous small-scale production systems. These challenges arise primarily from the prolonged retention of heat in the material, which leads to insufficient strength in the extruded strands at the macrostructural level. As a result, the component can collapse, a phenomenon known as 'slumping'. Thermal energy also influences microstructural changes, such as crystallisation kinetics, which affect properties such as the strength and stiffness of the final product. The duration and dynamics of thermal energy are influenced by manufacturing parameters and the possible use of additional peripheral equipment, which affects component quality. In this study, the influence of thermal energy on structural processes through simulations of polyamide 6 with 40% carbon fibres (PA6 wt.%40 CF) is investigated. The results show that by adjusting the process parameters and using modification units, the thermal profile of the material can be accurately controlled, which allows the microstructural processes to be precisely controlled. This leads to the targeted modification of the macroscopic material properties. The focus of this work is on the combination of numerical simulations of the LS-MEX process with semi-empirical methods for the analysis of crystallisation processes. The application of the Nakamura model, which is used throughout similar investigations, allows a detailed description and prediction of the crystallisation kinetics during the manufacturing process. The study shows that the absolute degree of crystallisation can be determined with simplified assumptions using a combination of thermal simulations and semi-empirical approaches. It was found that the absolute degree of crystallisation increases from the outer interface of the strand to the print bed across the cross-section. This can be attributed to the specific thermal boundary conditions and the resulting temperature profiles at different points.