Application and study on preparation of bio-asphalt by modified phenolic resin from corn straw tar

XPS, GPC, FT-IR, and GC-MS analyses were conducted on corn straw tar and 70# petroleum asphalt. The results indicate that the sulfur content in corn straw tar is lower than that in petroleum asphalt, potentially mitigating the volatilization of harmful substances upon substituting petroleum asphalt. This finding serves as evidence for the substantial presence of phenolic substances in corn straw tar. Upon employing the BOX-Behnken response surface analysis and utilizing resin yield as the evaluation index, the significance of three factors was established as follows: reaction time > phenol molar ratio > straw tar content. Based on the secondary multiple regression model, the optimal conditions for synthetic resin production are a phenolic mole ratio of 0.8, a reaction time of 125 min, and a straw tar dosage of 10 %. An assessment of resin viscosity at different VI temperatures reveals that corn stover tar can partially replace phenol and formaldehyde in the condensation reaction. Additionally, viscosity improvement is observed at elevated temperatures. Thermal gravimetric(TG) spectroscopy indicates lower mass loss in B-PF resin at high temperatures compared to PF resin or corn stover tar. In the evaluation of biological bitumen performance, it is discerned that the mixing amount of the prepared biological bitumen should be controlled at approximately 10 % of its performance. This ensures optimal efficacy without adversely affecting the performance of petroleum bitumen.