Related Experiment Video

Updated: Jun 24, 2025

Measurement of the Rheology of Crude Oil in Equilibrium with CO2 at Reservoir Conditions
10:38

Measurement of the Rheology of Crude Oil in Equilibrium with CO2 at Reservoir Conditions

Published on: June 6, 2017

12.7K

Measurements and PR EoS Modeling of Thermophysical Properties at Vapor-Liquid Equilibrium Conditions for Natural Gas

Sayyedvahid Bamzad1, Mahmood Abdi1, Shadi Kheirollahi1

  • 1Department of Chemical & Petroleum Engineering, Schulich School of Engineering, University of Calgary, Calgary, Alberta T2N 1N4, Canada.

ACS Omega
|June 3, 2024
PubMed

More Related Videos

Protocol for Measuring the Thermal Properties of a Supercooled Synthetic Sand-water-gas-methane Hydrate Sample09:46

Protocol for Measuring the Thermal Properties of a Supercooled Synthetic Sand-water-gas-methane Hydrate Sample

Published on: March 21, 2016

8.9K
Fast Pyrolysis of Biomass Residues in a Twin-screw Mixing Reactor07:30

Fast Pyrolysis of Biomass Residues in a Twin-screw Mixing Reactor

Published on: September 9, 2016

27.7K

Related Concept Videos

Vapor Pressure02:34

Vapor Pressure

When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...
34.8K
Distillation: Vapor–Liquid Equilibria01:01

Distillation: Vapor–Liquid Equilibria

Distillation is a separation technique that takes advantage of the boiling point properties of disparate elements in a mixture. To perform distillation, we begin by heating a miscible mixture of two liquids with a significant difference in boiling points (at least 20°C). As the solution heats up and reaches the bubble point of the more volatile component, some molecules of the more volatile component transition into the gas phase and travel upward into the condenser, which is a glass tube...
2.8K
Clausius-Clapeyron Equation02:35

Clausius-Clapeyron Equation

The equilibrium between a liquid and its vapor depends on the temperature of the system; a rise in temperature causes a corresponding rise in the vapor pressure of its liquid. The Clausius-Clapeyron equation gives the quantitative relation between a substance’s vapor pressure (P) and its temperature (T); it predicts the rate at which vapor pressure increases per unit increase in temperature.
56.6K
Vapor Pressure of Fluid01:28

Vapor Pressure of Fluid

The vapor pressure of a fluid is a crucial concept in fluid mechanics, influencing phenomena such as boiling and cavitation. Vapor pressure refers to the pressure exerted by a vapor at a state of thermodynamic equilibrium with its corresponding liquid phase at a specific temperature. It represents the tendency of molecules to escape from the fluid surface into the vapor phase.
When a liquid is placed in a closed container with a small air space, and the space is evacuated, vapor molecules will...
1.3K
Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase...
17.5K
pV-Diagrams01:18

pV-Diagrams

The pV diagram, which is a graph of pressure versus volume of the gas under study, is helpful in describing certain aspects of the substance. When the substance behaves like an ideal gas, the ideal gas equation describes the relationship between its pressure and volume. On a pV diagram, it is common to plot an isotherm, which is a curve showing p as a function of V with the number of molecules and the temperature fixed. Then, for an ideal gas, the product of the pressure of the gas and its...
4.1K