Related Experiment Video

Updated: Aug 14, 2026

Simulation, Fabrication and Characterization of THz Metamaterial Absorbers
13:44

Simulation, Fabrication and Characterization of THz Metamaterial Absorbers

Published on: December 27, 2012

15.3K

Low loss, wideband, and high extinction ratio TM polarizer based on subwavelength gratings

Haoyu Wu, Yaohui Sun, Yue Zhou

    Applied Optics
    |June 10, 2024
    PubMed

    More Related Videos

    Microwave Photonics Systems Based on Whispering-gallery-mode Resonators12:18

    Microwave Photonics Systems Based on Whispering-gallery-mode Resonators

    Published on: August 5, 2013

    17.0K
    Fabrication of High Contrast Gratings for the Spectrum Splitting Dispersive Element in a Concentrated Photovoltaic System12:08

    Fabrication of High Contrast Gratings for the Spectrum Splitting Dispersive Element in a Concentrated Photovoltaic System

    Published on: July 18, 2015

    10.7K

    Related Concept Videos

    Characteristics of Series Resonant Circuit01:24

    Characteristics of Series Resonant Circuit

    Series resonance occurs in a circuit containing inductive (L), capacitive (C), and resistive (R) elements connected sequentially. At the resonance frequency, the inductive and capacitive reactances are equal in magnitude but opposite in sign, effectively canceling each other. This causes the circuit's impedance is minimal, primarily determined by the resistance R. The resonant frequency of an RLC circuit is defined as:
    Parallel Resonance01:23

    Parallel Resonance

    The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by:
    Configurations of BJT01:16

    Configurations of BJT

    Bipolar Junction Transistors (BJTs) are categorized into various types based on their configurations, each with distinct characteristics and applications. The configurations are primarily differentiated by which terminal—base, emitter, or collector—is common to both the input and output circuits.
    The common base configuration is noted for its high voltage gain, positioning it as an ideal choice for single-stage amplifier circuits, such as microphone pre-amplifiers. A notable characteristic of...
    BJT Amplifiers01:14

    BJT Amplifiers

    Bipolar Junction Transistors (BJTs) are pivotal components in amplifier circuits, functioning as voltage-controlled current sources in their active region. This characteristic allows them to efficiently control the collector current through variations in the base-emitter voltage. Essentially, BJTs amplify power due to their ability to take a weak input signal and output a much stronger signal.
    In BJT amplifier configurations, particularly in common-emitter setups, the transistor's role extends...
    Time and frequency -Domain Interpretation of PI Control01:27

    Time and frequency -Domain Interpretation of PI Control

    Proportional-Integral (PI) controllers are essential in many control systems to improve stability and performance. They are commonly used in everyday devices like thermostats to enhance system damping and reduce steady-state error. When the zero in the controller's transfer function is optimally placed, the system benefits significantly in terms of stability and accuracy.
    Acting as a low-pass filter, the PI controller slows the system's response and extends settling times. This requires careful...
    Lossless Lines01:23

    Lossless Lines

    In electrical engineering, a lossless transmission line is characterized by a purely imaginary propagation constant and a resistive characteristic impedance. The ABCD parameters, which describe the relationship between the input and output voltages and currents, indicate an equivalent π circuit with an imaginary series impedance and a shunt admittance. This results in a transmission line that, when the product of the phase constant (beta) and the length of the line is less than pi, exhibits...