Incoherent partial superposition modeling for single-shot angle-resolved ellipsometry measurement of thin films on...

Ellipsometric measurement of transparent samples suffers from substrate backside reflection challenges, including incoherent and partial superposition issues. The recently developed angle-resolved ellipsometry (ARE) can naturally eliminate the backside reflections of substrates with a micro-spot equivalent thickness or thicker; however, for thinner substrates, ARE working with general incoherent backside reflection models shows significant inaccuracy or measurement failure. In this paper, an incoherent partial superposition (IPS) model is proposed to characterize the optical superposition effect between the frontside and uncertain backside reflections from an unknown substrate. IPS introduces a cosine-like correction of the backside reflection, corresponding to the overlapping-area change of backside and frontside reflections along with incident angles. Benefiting from ARE's wide-angle spectral imaging capability, IPS achieves single-shot measurement of thin film thicknesses on transparent substrates of unknown thickness. An ARE system was built and calibrated regarding the linear relationship between the cosine-corrected angular frequencies and substrate thicknesses. Then, commercial ITO films on glasses of different thicknesses ranging from 200 to 1000 µm were measured. Experimental results show that IPS-ARE results in a root-mean-square accuracy error of ∼1 nm in film thickness measurement and provides a ∼77% error reduction from general incoherent backside reflection models.