Related Experiment Video
Updated: Jun 24, 2025

Development of Amelogenin-chitosan Hydrogel for In Vitro Enamel Regrowth with a Dense Interface
Published on: July 10, 2014
The flapless approach with and without enamel matrix derivatives for the treatment of intrabony defects: A randomized
Mario Aimetti1, Morta Stasikelyte1, Giulia Maria Mariani1
1Department of Surgical Sciences, C.I.R. Dental School, University of Turin, Turin, Italy.
Aim:
To compare the clinical and radiographic outcomes of flapless procedure alone or in combination with enamel matrix derivatives (EMD) in the treatment of deep intrabony defects.
Materials And Methods:
Forty-six patients re-evaluated after non-surgical therapy were randomly assigned to the test (flapless with EMD) or control group (flapless alone). Clinical measurements were recorded pre-surgery and at 6 and 12 months after surgery, and radiographic measurements were taken pre-surgery and after 12 months.
Results:
Forty-six patients completed the study. Improvements were observed in both groups at 12 months for mean clinical attachment level (CAL) gain, with significant differences between test (3.9 ± 1.1 mm) and control groups (3.0 ± 1.2) (p = .017). Probing pocket depth (PPD) reduction (4.0 ± 0.7 vs. 3.3 ± 1.4 mm) was also near to statistical significance (p = .051). Also, more sites achieved successful composite outcome measure (final PPD ≤ 4 mm and CAL gain ≥3 mm) for the regenerative treatment in the flapless + EMD group (82.6% vs. 52.2%; p = .028). In terms of radiographic outcomes, EMD yielded a greater defect bone fill than flapless treatment alone (3.0 ± 1.0 mm vs. 1.8 ± 1.5 mm; p < .001).
Conclusions:
The additional application of EMD during the flapless procedure for intrabony defects slightly improved clinical and radiographic outcomes.
Clinicaltrials:
gov identification number: NCT05456555.
More Related Videos
10:42A Postoperative Evaluation Guideline for Computer-Assisted Reconstruction of the Mandible
Published on: January 28, 2020
07:42Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024