DIW-Printed Thermal Management PDMS Composites with 3D Structural Thermal Conductive Network of h-BN Platelets and...

Electronic devices play an increasingly vital role in modern society, and heat accumulation is a major concern during device development, which causes strong market demand for thermal conductivity materials and components. In this paper, a novel thermal conductive material consisting of polydimethylsiloxane (PDMS) and a binary filler system of h-BN platelets and Al₂O₃ nanoparticles was successfully fabricated using direct ink writing (DIW) 3D printing technology. The addictive manufacturing process not only endows the DIW-printed composites with various geometries but also promotes the construction of a 3D structural thermal conductive network through the shearing force during the printing process. Moreover, the integrity of the thermal conductive network can be optimized by filling the gaps between the BN platelets with Al₂O₃ particles. Resultingly, the configuration of the binary fillers is arranged by the shearing force during the DIW process, fabricating the thermal conductive network of oriented fillers. The DIW-printed BN/Al₂O₃/PDMS with 45 wt% thermal conductive binary filler can reach a thermal conductivity of 0.98 W/(m·K), higher than the 0.62 W/(m·K) of the control sample. In this study, a novel strategy for the thermal conductive performance improvement of composites based on DIW technology is successfully verified, paving a new way for thermal management.