Accelerated flushing of contaminants from MSW landfill at the field scale using a fill-and-draw method

A fill-and-draw flushing test on a landfill cell containing MSW waste was carried out to examine the operational viability of this method for accelerating the flushing of contaminants and landfill stabilisation. During the fill cycle, 800 m³ of water containing the tracer bromide was pumped into the base of a 0.44 ha landfill cell, resulting in the estimated saturation of 9,400 m³ of waste. Abstraction took place in two phases, during which 1,100 m³ of tracer/leachate was recovered. Samples of leachate were analysed for the tracer, electrical conductivity and indigenous solutes chloride and ammonia. Tracer recovery was between 63 and 72 % for bromide. An estimated 227 kg of ammonia and 575 kg of chloride were removed. Test data was used to calibrate a 1D, dual-porosity model involving advection in a mobile zone, and diffusion into 'blocks' of a less mobile zone. The model fitted well to the early time data, whereas later data appears to have been affected by recharge. The results of this trial demonstrate the possibilities of the 'fill-and-draw' concept using the basal leachate drainage system of landfills as a potential accelerated landfill remediation technique. However, modelling results suggest low contaminant removal efficiency. Including a pause between the fill and the draw cycles improves mass removal.