Related Experiment Video
Updated: Jun 23, 2025

High-Contrast and Fast Photorheological Switching of a Twist-Bend Nematic Liquid Crystal
Published on: October 31, 2019
The effect of particle geometry and initial configuration on the phase behavior of twisted convex n-prisms
Poshika Gandhi1, Anja Kuhnhold1
1Institute of Physics, University of Freiburg, Hermann-Herder-Str. 3, 79104 Freiburg, Germany. poshika.gandhi@physik.uni-freiburg.de.
Abstract:
We study the phase behavior of twisted convex n-prisms with n = 3 and 4, via Monte Carlo simulations. Biaxial phases, in untwisted prisms, can be induced by choosing specific geometries of the prisms. However, due to the convexity of the twisted particles, a strong twisting disables the formation of biaxial phases and stabilizes uniaxial nematic and smectic phases. Using the increased volume of the twisted convex particles, we define an effective aspect ratio of the twisted prisms and find a homogeneous phase behavior across the geometry of the prisms' cross-section and even across different shapes of the cross-section. In this representation biaxial phases are found for large aspect ratios, while the low aspect ratio behavior can be compared to the hard cylinder phase diagram. For 3-prisms with a small base angle, we show the influence of the initial configuration; a polar initial configuration results in a (polar) splay nematic phase, whereas a non-polar initial configuration results in a biaxial phase.
More Related Videos
08:54Synthesis and Exfoliation of Discotic Zirconium Phosphates to Obtain Colloidal Liquid Crystals
Published on: May 25, 2016
09:43Interfacial Molecular-level Structures of Polymers and Biomacromolecules Revealed via Sum Frequency Generation Vibrational Spectroscopy
Published on: August 13, 2019
Related Concept Videos
Transformation of Plane Stress
Deformations in a Symmetric Member in Bending
When the member is segmented into tiny cubic elements, it is observed that the primary stress...
Symmetric Member in Bending
Three-Dimensional Analysis of Strain
Plastic Deformations of Members with a Single Plane of Symmetry
Design of Prismatic Beams for Bending