Healing of Extraction Sites after Alveolar Ridge Preservation Using Advanced Platelet-Rich Fibrin: A Retrospective...

Over time, numerous surgical procedures and biomaterials have been proposed for the reconstruction of post-extraction bone defects, each with their advantages and disadvantages. The main objective of this study was to evaluate dimensional changes in the alveolar bone 3 months after tooth extraction, before implant planning, comparing alveolar ridge preservation (ARP) with spontaneous healing.

A total of 84 patients with non-restorable molars were included in the study. Forty-two patients received ARP with advanced platelet-rich fibrin (A-PRF) and spontaneous healing was evaluated in these patients. Cone beam computed tomography (CBCT) analysis performed before and after surgical intervention was used to determine the changes in vertical and horizontal bone dimensions produced after tooth extraction.

CBCT measurements showed reduction in both vertical and horizontal alveolar bone size in both groups. For the study group, the alveolar parameters (height, width) were higher compared to the control group. The percentage variations between dimensional differences from the two groups were 38.58% for height, and for width were 36.88% at 0 mm, 35.56% at 3 mm, 36.61% at 5 mm, and 38.73% at 7 mm. The differences were statistically significant (p ˂ 0.0005).

The results obtained after ARP with A-PRF showed a reduced loss of bone volume compared to spontaneous healing.