The Influence of Heat Treatment on the Microstructure and Properties of a Cu-Bearing Ultra-Low Carbon Steel

This study reveals the relationship between the Cu precipitates and mechanical properties of a Cu-baring ultra-low carbon steel after two-phase zone quenching and tempering at 923 K for 0.5-2.5 h. The tensile and microstructural properties were investigated as a function of heat treatment time. The contribution of the precipitation-strengthening mechanism to yield strength was calculated. The size, morphology, and distribution of the precipitated particles were observed using TEM. As the heat treatment time increased, the strength gradually decreased and then remained stable, and the elongation gradually increased and then remained stable. Additionally, the contributions of each strengthening mechanism to the yield strength under different heat treatments were 117, 107, 102, and 89 MPa, respectively. The size and quantity of the precipitates increased with the increase in heat treatment time. After tempering for more than 2 h, the precipitates continued to coarsen, but their quantity decreased. The precipitated Cu had a 3R structure with a length of approximately 17.1 nm and a width of approximately 9.7 nm, with no twinning inside. The stacking order was ABC/ABC. The stable Cu precipitation structure was FCC, maintaining a K-S orientation relationship 11¯1_{FCC Cu} //(0 1 1) _α, 1¯10_{FCC Cu}//[11¯1] _α.