Synthesis and Evaluation of Plugging Gel Resistant to 140 °C for Lost Circulation Control: Effective Reduction in...

Gel plugging agents have become one of the preferred methods for plugging in complex and severe loss conditions during drilling due to their good adaptability to loss channels. To address the common issue of poor temperature resistance in gel-based plugging agents, high-temperature-resistant gel plugging materials were synthesized through the molecular design of polymers, modifying existing agents. Based on the temperature and salt resistance of the aqueous solution of an acrylamide (AM)/N-vinylpyrrolidone (NVP) binary copolymer, temperature-resistant monomer sodium styrene sulfonate (SSS) was introduced and reacted in a polyvinyl alcohol (PVA) aqueous solution. Using ammonium persulfate (APS) as an initiator and crosslinking with N,N-methylenebisacrylamide (MBA), a gel plugging material resistant to 140 °C was synthesized. The structure, thermal stability, water absorption and expansion, and plugging performance of the gel were studied through hot rolling aging, thermogravimetric analysis, infrared spectroscopy, electron microscopy scanning, sand bed experiments, and drag reduction experiments. The results show that the gel material has good thermal stability and water absorption and expansion at 140 °C, and its temperature-resistant plugging performance is excellent, significantly slowing down the loss rate of drilling fluid. This provides a basis for the further development of gel materials.