DNA typing of cyanoacrylate fumed latent fingerprints using GlobalFiler™ and ForenSeq™ Signature Prep kits

DNA typing of latent fingerprints is highly desirable to increase chances of individualization. We recovered DNA from Cyanoacrylate (CA) fumed fingerprints and used both GlobalFiler™ and ForenSeq™ DNA Signature Prep kits for DNA typing. For GlobalFiler™, samples were processed using a protocol modified for Low Template (LT)-DNA samples (half-volume reactions, 30 cycles) while for ForenSeq™ DNA Signature Prep, samples were processed using a standard protocol and fluorometer-based library quantitation. We evaluated genotyping success and quality of profiles in terms of completeness, Peak Height Ratio/Allele Coverage Ratio, presence of PCR artifacts and drop-in alleles. With GlobalFiler™, average autosomal STR (aSTR) profile completeness was 44.4% with 2-20 pg, 54.3% with 22-60 pg, and 95% with 64-250 pg DNA input. CODIS uploadable profiles were obtained in 2/10, 3/11, and 11/12 samples in these ranges. With ForenSeq™ DNA Signature Prep, average aSTR profile completeness was 19.7% with 1-20 pg and 45.2% with 22-47 pg but increased to 78.3% with 68-122 pg and 86.7% with 618-1000 pg DNA input. Uploadable profiles were obtained in 0/12, 4/11, 4/7, and 3/3 samples for these ranges. Results show very high sensitivity using both kits. Half-volume reactions and 30 cycles had minimal negative effect on Globalfiler™ profile quality, providing support for wider use after validation experiments to routinely improve results from LT samples. A standard protocol for the ForenSeq™ DNA Signature Prep kit was also highly successful with LT DNA obtained from CA-fumed fingerprints with additional information from isometric STR alleles and other markers.