Tunable thermoresponsive hydrogels for temperature regulation and warning in fruit and vegetables preservation
Libin Sun1, Da-Wen Sun2, Liang Xu1
1School of Food Science and Engineering, South China University of Technology, Guangzhou 510641, China; Academy of Contemporary Food Engineering, South China University of Technology, Guangzhou Higher Education Mega Center, Guangzhou 510006, China; Engineering and Technological Research Centre of Guangdong Province on Intelligent Sensing and Process Control of Cold Chain Foods, & Guangdong Province Engineering Laboratory for Intelligent Cold Chain Logistics Equipment for Agricultural Products, Guangzhou Higher Education Mega Centre, Guangzhou 510006, China.
Abstract:
Fresh fruit and vegetables usually suffer from quality deterioration when exposed to inappropriate temperatures. Common energy-input temperature regulation is widely applied but there remain challenges of increasing energy consumption. Passive temperature management regulates the heat transfer without energy consumption, showing a sustainable strategy for food preservation. Here, thermoresponsive hydrogels were constructed by incorporating NaCl and sodium dodecyl sulfate (SDS) micelles into a poly(N-isopropylacrylamide-co-acrylamide) (P(NIPAM-co-AM)) network. Due to the excellent mechanical properties and reversible thermochromism at 14 °C and 37 °C, Gel-8 wt%-NaCl could inhibit temperature rise and avoid sunburn damage to peppers under direct sunlight by blocking the input of solar energy and accelerating moisture evaporation. Additionally, hydrogels could act as a feasible sensor by providing real-time visual warnings for inappropriate temperatures during banana storage. Based on the self-adaptive thermoresponsive behaviour, the prepared hydrogels showed effective performance of temperature regulation and quality preservation of fruit and vegetables.
More Related Videos
08:39Magnetic and Thermal-sensitive PolyN-isopropylacrylamide-based Microgels for Magnetically Triggered Controlled Release
Published on: July 4, 2017
10:49Printing Thermoresponsive Reverse Molds for the Creation of Patterned Two-component Hydrogels for 3D Cell Culture
Published on: July 10, 2013
