Role and Results of Constrained Insert in Computer-Assisted Primary Total Knee Arthroplasty: A Propensity-Matched...

Mild ligament imbalance is often encountered in the mediolateral plane during complex primary total knee arthroplasty. A constrained (CP) polyethylene insert compatible with the primary femur is useful to manage these cases without the need to fall back on revision implants. The aim of the study was to define the correct indications of the use of a CP insert based on objective data from computer assisted surgery and to compare the early results of a CP insert with a standard posterior stabilized (PS) insert through one-to-one propensity score matching.

This is a retrospective case study from a prospectively collected database. One-to-one matching without replacement was used with a caliper width of 0.2 to match the scores between CP (N = 64) and PS groups (N = 1624), resulting in equal covariate matching of PS (N = 64) and CP (N = 64) cohorts. Patients were assessed radiographically and functionally at a minimum follow-up of 3 years.

Average coronal and sagittal plane deformities were similar in both the group CP (varus 13.1 ± 5.2 valgus 13 ± 7.9) and the group PS (varus 13.4 ± 4.6 valgus 10.9 ± 8.6). The average residual medial lateral gap difference was significantly higher in group CP (3.8 ± 1.8) in comparison to group PS (1.3 ± 1) (P < .05). A CP insert was chosen where mild ligament imbalance of 3-5 mm persisted after medial soft tissue releases in a varus knee and in cases with residual medial collateral ligament laxity in valgus knees.

Constrained insert used with the primary femoral component is a valuable option to handle mild ligamentous instability in complex primary total knee arthroplasty after mechanical alignment is achieved with computer navigation.

III.