Polymerase Chain Reaction and Dot-Blot Hybridization for Leptospira Detection in Water Samples

The dot-blot is a simple, fast, sensitive, and versatile technique that enables the identification of minimal quantities of DNA specifically targeted by probe hybridization in the presence of carrier DNA. It is based on the transfer of a known amount of DNA onto an inert solid support, such as a nylon membrane, utilizing the dot-blot apparatus and without electrophoretic separation. Nylon membranes have the advantage of high nucleic acid binding capacity (400 µg/cm²), high strength, and are positively or neutrally charged. The probe used is a highly specific ssDNA fragment of 18 to 20 bases long labeled with digoxigenin (DIG). The probe will conjugate with the Leptospira DNA. Once the probe has hybridized with the target DNA, it is detected by an anti-digoxigenin antibody, allowing its easy detection through its emissions revealed in an X-ray film. The dots with an emission will correspond to the DNA fragments of interest. This method employs the non-isotopic labeling of the probe, which may have a very long half-life. The drawback of this standard immuno-label is a lower sensitivity than isotopic probes. Nevertheless, it is mitigated by coupling polymerase chain reaction (PCR) and dot-blot assays. This approach enables the enrichment of the target sequence and its detection. Additionally, it may be used as a quantitative application when compared against a serial dilution of a well-known standard. A dot-blot application to detect Leptospira from the three main clades in water samples is presented here. This methodology can be applied to large amounts of water once they have been concentrated by centrifugation to provide evidence of the presence of Leptospiral DNA. This is a valuable and satisfactory tool for general screening purposes, and may be used for other non-culturable bacteria that may be present in water, enhancing the comprehension of the ecosystem.