Laboratory investigations of wave-induced transport of plastic debris over a rippled bottom

Laboratory experiments are conducted in a wave flume to investigate the effect of water waves on the transport of plastic pellets over a rippled bottom. The horizontal velocities of plastic debris are analyzed over the rippled bottom for different wave conditions and plastic elements with different properties. Laboratory investigations determined the characteristic transport patterns of wave-induced plastic debris with a density of ∼2.0g/cm3 moving along the rippled bottom. In the first, swing-type motion, the grains move only in the ripple trough with velocities lower than 0.10 m/s. For sliding-type movement, the grains move along the entire rippled surface with velocities in the range of 0.10-0.13 m/s. For higher velocities in the range of 0.15-0.20 m/s, a saltation-type motion becomes dominant. The results show that plastic grains may move up to 2-3 cm above the ripple crest depending on hydrodynamic conditions. The analysis shows that for velocity-skewed flows, sliding-type motion and onshore transport dominate. For acceleration-skewed flows, saltation-type motion and offshore transport dominate, which is attributed to higher boundary layer thickness and phase lag effects. The analysis of the relationship between the particle Reynolds number and the thickness of the turbulent boundary layer reveals that for values of Re_p≥1000 and a boundary layer thickness mm saltation-type motion becomes dominant. The direction of transport is affected not only by the density of the sediment and the wave skewness coefficients but also by the dimensions of the bottom ripples. The laboratory investigations also provide insight into the hydrodynamic conditions affecting the transport of plastic debris along the bottom covered with ripples in oscillating nonlinear water flows.