Comparing hoof dimensional measurements in cows based on 3D image creation and manual measurement

In this study, the accuracy of using 3D measurements from a 3D image creation application (3DICA) as a potential tool for measuring hoof dimensions in cattle was determined. Fifty distal limbs of cattle obtained from a slaughterhouse were included after the data was trimmed by the functional hoof trimming method. The lengths of six dimensional variables determined by manual measurements served as the true values. Then, the images of these hooves were captured with the 3DICA, and the same variables were determined by the measurement function in the 3DICA. A strong positive correlation was obtained between the 3D and manual measurements for five of the six points, and the mean difference was within 2 mm at all six points. However, the limits of agreement varied at three of the six points. In conclusion, compared with manual measurements, the 3D measurements provided approximately equivalent measurements for the hoof dimensions. However, these findings are preliminary, and further investigations are needed.