Related Experiment Video
Updated: Jun 21, 2025

Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters
Published on: February 4, 2018
Design of dual mode antenna using CMA and broadband dual-polarized antenna for 5G networks
N Sathishkumar1, SatheeshKumar Palanisamy2, Rajesh Natarajan3
1Department of Electronics and Communication Engineering, KPR Institute of Engineering and Technology, Coimbatore, Tamil Nadu, 641407, India.
Abstract:
This article proposes a dual mode dual-polarized antenna configuration for IRNSS and fifth generation (5G) applications, operating at a frequency of 3.5 GHz based on characteristic mode analysis (CMA), and aims to provide broadband dual-polarized functionality. The original design of the antenna is a traditional patch antenna, and its dual-polarized features are determined using characteristic mode analysis. The full-wave method is used to stimulate both orthogonal modes using a 50 Ω coaxial input line at 3.5 GHz. In this design, the circular patch has been extended into an elliptical patch through a process of mode separation. The circular patch exhibits resonance at a frequency of 2.5 GHz, whereas the extended elliptical radiator demonstrates two resonance modes at 2.5 GHz and 3.5 GHz. The operational mechanism is elucidated by modal analysis and characteristic angle. This antenna operates on two different frequencies at the 2.5 GHz IRNSS band with horizontal polarization and the 3.5 GHz 5G service with vertical polarization. The maximum gain achieved with these frequency ranges is 5.31 dBi and 4.72 dBi, respectively. A ring resonator is chosen to improve the axial ratio and impedance bandwidth of the suggested prototype. The antenna's ground plane is shaped like a rectangle and features a V-shaped slot in the radiating patch. The antenna's physical footprint is 50 mm × 50 mm × 1.6 mm and an FR4 dielectric substrate serves as its foundation. Through its interaction with a PIN diode, the diode modifies the polarization of the antenna. The antenna functions as a right-handed circular polarization (RHCP), when the diode is operational. The bandwidth from 4.3 to 7.5 GHz is covered. On the other hand, it generates linear polarization (LP) between 4.2 and 5.3 GHz. The experimental antenna is evaluated and examined for its performance characteristics. The simulations are carried out utilizing the CST simulator. A prototype antenna has been manufactured and its performance has been validated against simulated findings.
More Related Videos
10:35Using Microwave and Macroscopic Samples of Dielectric Solids to Study the Photonic Properties of Disordered Photonic Bandgap Materials
Published on: September 26, 2014
06:43Effective Analysis of Human Exposure Conditions with Body-worn Dosimeters in the 2.4 GHz Band
Published on: May 2, 2018
Related Concept Videos
Mesh Analysis for AC Circuits
The process of harmonizing these impedances begins with a clear understanding of the input and output signals. Once these signals are known, the...
Transmission Line Design Considerations
Design Example
Modeling of Diode Forward Characteristics
Design Example: Capacitance Multiplier Circuit
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Modeling of Diode Reverse Characteristics
When a reverse voltage applied to a Zener diode exceeds its breakdown voltage, the diode enters the breakdown region. At this point, the...