Numerical simulation on transient electromagnetic response of separation layer water in coal seam roof

Mining stress induces deformation and fracture of the overlaying rock, which will result in water filling the separation layer if the aquifer finds access to abscission space along the fracture channels. Accurate detection is crucial to prevent water hazards induced by water-bearing fractures. The 3-D time-domain finite-difference method with Yee's grid was adopted to calculate full-space transient electromagnetic response; meanwhile, a typical geologic and geophysical model with a water-bearing block in an separation layer was built according to regional tectonics and stratigraphic developments. By using numerical simulation, the induced voltage and apparent resistivity for both vertical and horizontal components were acquired, and then an approximate inversion was carried out based on the "smoke ring" theory. The results indicate that the diffusion velocity of induced voltage is significantly affected by the water-bearing body in the fracture, and the horizontal velocity of induced voltage is lower than the vertical one. The induced voltage curves indicate that the horizontal response to an anomaly body is stronger than the vertical one, leading to a high apparent resistivity resolution of conductivity contrast and separation layer boundary in the horizontal direction. The results of 3-D simulation making use of a measured data model also demonstrate that the horizontal component of apparent resistivity can reflect the electrical structure in a better way; however, its ability to recognize the concealed and fine conductor is rather weak. Accordingly, the observation method or numerical interpolation method needs to be further improved for data processing and interpretation.