Effect of Biomass Torrefaction on the Syngas Quality Produced by Chemical Looping Gasification at 20 kW_th Scale

The innovative Biomass Chemical Looping Gasification (BCLG) process uses two reactors (fuel and air reactors) to generate nitrogen-free syngas with low tar content under autothermal conditions. A solid oxygen carrier supplies the oxygen for partial oxidation of the fuel. This study investigated the BCLG process, conducted over 25 h of continuous operation at 20 kW_th scale, using ilmenite as the oxygen carrier and wheat straw pellets as fuel (WSP). The effect of using torrefied wheat straw pellets (T-WSP) on the syngas quality was assessed. In addition, the impact of several operational variables on the overall process performance and syngas yield was analyzed. The primary factors influencing the syngas yield were the char conversion through gasification and the oxygen-to-fuel ratio. Higher temperatures, extended residence times of solids in the fuel reactor, and using a secondary gasifier led to increased char conversion, enhancing H₂ and CO production. Optimizing the air reactor design could enhance the CO₂ capture potential by inhibiting the combustion of bypassed char. While char conversion and syngas yield with T-WSP were lower than those with WSP at temperatures below 900 °C, T-WSP achieved a higher syngas yield under conditions favoring high char conversion. The presence of CH₄ and light hydrocarbons showed minimal sensitivity to operating conditions variation, limiting the theoretical syngas yield. Overall, the CLG unit operated smoothly without any agglomeration issues.