Probing Viscoelastic Properties and Interfaces in High-Density Polyethylene Vitrimers at the Nanoscale Using Dynamic...

Vitrimers are a new class of heterogeneous polymers that combine the best features of thermosets with those of thermoplastics. The introduction of cross-links strongly changes the viscoelastic behavior of vitrimer materials. However, the characterization and understanding of the nanostructures and interfaces in vitrimers resulting from dynamic cross-linking formation remain a major challenge. Here, using dynamic modes of atomic force microscopy (AFM), namely intermodulation AFM (ImAFM) and AFM-based dynamic mechanical analysis (AFM-nDMA), local viscoelastic properties and interfaces at the nanoscale length of high-density polyethylene (HDPE) vitrimer materials are reported. ImAFM imaging in combination with the k-means clustering algorithm clearly reveals two distinct phases in the vitrimer system with highly different viscoelastic properties. AFM-nDMA further provides quantitative nanoviscoelastic properties at the nanoscale to confirm that there is a cross-linking-rich aggregation area forming a nanosize network structure in the cross-linking-poor matrix phase. The cross-linking-rich region shows a similar elastic modulus but much higher adhesion force measured by AFM compared to the cross-linking-poor HDPE matrix. Furthermore, the frequency influence on the local viscoelastic properties of HDPE vitrimer at the nanoscale was initially screened. The observed HDPE vitrimer nanostructures and viscoelastic properties at the nanoscale also provide explanations on the observed bulk HDPE vitrimer crystallinity decrease and dimensional stability increase compared to HDPE. Therefore, probing the viscoelastic properties and interfaces of HDPE vitrimer provides important insights into understanding of the correlations between the vitrimer nanostructure and the bulk mechanical and rheological behaviors.