Characteristics of pollutant generation from 3D-printed photocured waste combustion

With the rapid advancement of photopolymerization-based 3D printing technology, the volume of PCW has experienced a sharp increase. The potential environmental ramifications of PCW disposal demand careful consideration, especially given its current practice of being incineration alongside MSW. In this study, the TG-MS/FTIR system was carried out to probe the thermogravimetric characteristics and volatile byproducts during combustion. Various product compositions resulting from different mixing ratios of PCW incineration with MSW were investigated. It was observed that fluorene (C₁₃H₁₀) and triphenylene (C₁₈H₁₂) produced by PCW combustion 0.52 mg/g and 0.43 mg/g respectively, which are twice as abundant as those generated from normal plastic. When PCW incineration along with MSW, compounds such as naphthalene (C₁₀H₈), cyclohexane (C₆H₁₂), and heptane (C₇H₁₆) were generated in concentrations of 1.25 mg/g, 1.05 mg/g, and 0.95 mg/g respectively, which are at least twice as much as with MSW incineration alone. The incineration of PCW with rubber and textiles resulted in the production of 2.34 mg/g to 3.76 mg/g more PAHs compared to PCW combustion alone. The incineration of PCW with paper resulted in the production of 3.12 mg/g to 5.15 mg/g more heptane, nonane, cyclohexane, pyrene, and anthracene than PCW combustion alone. Incineration of PCW with wood proved to be the cleanest method, with product contents primarily below 0.10 mg/g. When incinerated with food residues or normal plastic, most of the product content remained below 0.05 mg/g. Considering the environmental pollution resulting from PCW combustion, the disposal of PCW warrants careful consideration and management.