Event-triggered prescribed-time control for a class of uncertain nonlinear systems using finite time-varying gain
Huanyu Yang1, Yujuan Wang1, Zhuwu Shao1
1State Key Laboratory of Power Transmission Equipment & System Security and New Technology, and School of Automation, Chongqing University, Chongqing, 400044, China.
Abstract:
This paper addresses the event-triggered prescribed-time control problem for a class of high-order nonlinear systems based on finite time-varying gain. Due to the existence of unknown gain functions and system uncertainties, the resultant control with prescribed-time convergence performance becomes nontrivial. The problem becomes even more complex due to the use of event-based communication instead of continuous communication. To tackle the aforementioned challenges, this paper proposes an event-triggered prescribed-time stabilization approach with the following key steps. Firstly, we establish a new prescribed-time stability lemma to overcome the technical difficulty arising from the prescribed-time controller design, and stability analysis. Secondly, we give the controller design procedure upon using the backstepping technique. Thirdly, we redesign the event-triggering threshold condition based on time-varying functions, which allows the controller terminal jitter to be mitigated and the controller to be implemented straightforwardly in practice. Furthermore, the proposed control scheme avoids Zeno behavior. The numerical simulation confirms the effectiveness of the proposed control scheme.
Related Concept Videos
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be...
Transient and Steady-state Response
These test signals are integral in designing control systems to exhibit two key performance aspects: transient response and steady-state...
Time and frequency -Domain Interpretation of PI Control
Acting as a low-pass filter, the PI controller slows the system's response and extends settling times. This requires...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...


