Related Experiment Video
Updated: Jun 21, 2025

Measurements of Waves in a Wind-wave Tank Under Steady and Time-varying Wind Forcing
Published on: February 13, 2018
Design and stability analysis of a new six-floater oscillating water column-based floating offshore wind turbine
Salvador Cayuela-Padilla1, Fares M'zoughi2, Izaskun Garrido2
1Automatic Control Group-ACG, Institute of Research and Development of Processes-IIDP, Department of Automatic Control and Systems Engineering, Faculty of Engineering of Bilbao, University of the Basque Country-UPV/EHU, Po Rafael Moreno no3, 48013, Bilbao, Spain. salvador.cayuela@ehu.eus.
Abstract:
The operational efficiency and lifespan of Floating Offshore Wind Turbines (FOWTs) are adversely impacted by the inherent platform motions and undesired vibrations induced by wind and wave loads. To effectively address these effects, the control of specific structural motions is of utmost importance, with platform pitch and yaw identified as the primary Degrees Of Freedom (DOF) that require attention. This study proposes a novel utilization of Oscillating Water Columns (OWCs) as a reliable and viable solution to mitigate platform pitch and yaw motions, thereby significantly enhancing the efficiency and reducing fatigue in wind turbines. This article aims to evaluate the impact resulting from integrating OWCs within each discrete floater of a Six-Floater platform. By considering different combinations of OWCs, a comprehensive analysis of the Response Amplitude Operators (RAOs) associated with pitch and yaw motions is presented. The primary objective is to identify the most efficient arrangements of OWCs and determine suitable combinations that effectively stabilize platform pitch and yaw motions. The empirical results substantiate that specific OWC configurations exhibit notable dampening effects on both pitch and yaw motions, particularly within specific wave frequency intervals. Consequently, it can be inferred that the integration and adequate operation of OWCs facilitate a substantial improvement in the stabilization of multi-floater platforms.
Related Concept Videos
Buoyancy and Stability for Submerged and Floating Bodies
Design Example: Calculating Safe Diameter for Wind-Exposed Disc
Stability of structures
Design Example: Creating a Hydraulic Model of a Dam Spillway
Damped Oscillations
Although friction and other non-conservative...
Fluid Pressure over Flat Plate of Variable Width
The pressure distribution on the plate can be calculated by determining the force that acts on a differential area strip of the plate. Thus, the magnitude of the force is equal to the...

