Tuning a Superhydrophobic Surface on an Electrospun Polyacrylonitrile Nanofiber Membrane by Polysulfone Blending

Nanofibers made of different materials have been continuously studied and widely used as membranes due to their simple fabrication techniques and tunable surface characteristics. In this work, we developed polyacrylonitrile (PAN) nanofiber membranes by the electrospinning method and blended them with polysulfone (PSU) to obtain superhydrophobic surfaces on the fiber structures. The scanning electron microscopy (SEM) images show that the fabricated nanofibers have smooth and continuous morphology. In addition, to observe the effect of the PSU-based blending material, Fourier-transform infrared (FTIR) spectra of the samples were acquired, providing chemical compositions of the bare and PSU-blended PAN nanofibers. The fabricated PSU/PAN composite nanofibers have a diameter range of 222-392 nm. In terms of the wettability, the measured water contact angle (WCA) value of the PAN nanofibers was improved from (14 ± 1)° to (156 ± 6)°, (160 ± 4)°, (156 ± 6)°, and (158 ± 4)° after being blended with PSU solutions having concentrations of 0.5, 1, 1.5, and 2 wt %, respectively. This result has proven that the PAN nanofiber surfaces can be tuned from hydrophilic to superhydrophobic characteristics simply by introducing PSU into the PAN solution prior to electrospinning, where a small PSU concentration of 0.5% has been sufficient to provide the desired effect. Owing to its low-cost and highly efficient process, this strategy may be further explored for other types of polymer-based nanofibers.