Related Experiment Video
Updated: Jul 15, 2026

Porcine As a Training Module for Head and Neck Microvascular Reconstruction
Published on: September 29, 2018
Safe and reliable use of supraclavicular flaps for head and neck reconstruction
1Department of Plastic and Reconstructive Surgery, Kyushu University Hospital, Fukuoka, Japan.
Abstract:
The supraclavicular flap is a regional flap in the supraclavicular area nourished by the transverse cervical or supraclavicular arteries. This flap gained popularity in the 2000s as it requires less surgical time than free flap reconstruction and has minimal donor-site morbidity. However, a high rate of postoperative complications has been reported. Moreover, there is ongoing debate regarding the indications and limitations of this flap. In this study, we confined the flap design to the supraclavicular fossa, considering flap vascularity and in an effort to minimize donor site morbidity. Between 2014 and 2023, we performed supraclavicular flap reconstruction in 3 cases of cervical skin defects and 1 case of a pharyngeal mucosal defect. The average defect and flap sizes were 7×3.9 cm and 11.5×4.4 cm, respectively. The lower border of the flap remained above the clavicle, and the lateral border did not exceed the acromioclavicular joint. When the flaps were transferred using the transposition method, the angle of transposition was limited to <90 degrees. When the VY advancement or turnover method was selected, we paid attention to the tension-free flap inset. We successfully reconstructed the defects without flap-related complications, and donor site scars were inconspicuous in all patients. In conclusion, we believe that confining the flap design to the supraclavicular fossa, limiting the indications of this flap to the reconstruction of medium-sized defects, and using tension-free flap insets are important for the successful application of this flap.
Related Concept Videos
Fractures: Bone Repair
Minor fractures with no bone displacement are treated by immobilizing the fractured bone using a cast or splint. However, in the case of fractures with displaced bones, the broken bones are repositioned before immobilization to ensure successful healing without deformation and loss of function. The realignment of fractured bone ends is performed through a process called reduction. If the procedure...
Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary or...

