Intrarenal pressure and flow rate profile using LithoVue™ elite: impact of different irrigation systems and working...

To report real-time IRP and FR while performing flexible ureteroscopy in porcine kidney model utilizing LithoVue™ Elite (Boston Scientific®) with different irrigation systems, including automated pumps.

Using an ex-vivo model of porcine kidney, IRPs were measured with LithoVue Elite. Ureteroscopic settings (US) were tested with all permutations of irrigation methods (IM), working channel occupant (WCO), and ureteral access sheaths (UAS). IMs included: Single Action Pumping System (SAPS™, Boston Scientific), Thermedx FluidSmart™ (Stryker®), and ENDOMAT™ (Karl Storz®). Pumps were tested at 50, 100, and 150 mmHg. WCOs included a 1.9Fr zero-tip basket, 200 µm, and 365 µm laser fibers. UASs utilized 11/13Fr and 12/14Fr 36 cm.

84 different US were tested (252 experiments). ENDOMAT had higher IRP but the same FR as Thermedx at the same US for 50 and 100 mmHg (p < 0.01). SAPS had higher IRP and FR than pumps in all US studies (p < 0.01). There was positive correlation between pressure set by the pump and both IRP and FR (rho > 0.9). As the diameter of the WCO increased, lower IRP and FR were observed with the pumps (p < 0.01). With SAPS, IRP was similar regardless of WCO, but FR was decreased with the increased diameter of WCO (p = 0.81 and p < 0.01, respectively). There was significantly higher IRP when using 11/13Fr UAS than 12/14Fr (p < 0.01).

IRP was higher with SAPS than automated pumps. ENDOMAT showed higher IRP than Thermedx when under 150 mmHg. IRP and FR increase with higher pump pressure and decrease with larger diameter WCO. Likewise, a larger UAS significantly reduced IRP.