Odours in Asphalt: Analysis of the Release of H₂S from Bitumen by a Mass Spectrometric Residual Gas Analyser

During the production and laying phases of hot-mixing asphalt (HMA), various volatile organic compounds (VOCs) and noxious gases such as H₂S are released into the atmosphere. These emissions are a serious environmental problem, a risk to human health, and expose workers and residents to unfriendly odours. The aim of this study was the development of a fast and sensitive analytical method to detect the H₂S emitted from hot bituminous binder that is generally used in the various stages of asphalt production, processing, handling and during road construction. The method consisted in the analysis of evolved H₂S from a flask with molten bitumen, using nitrogen as a carrier gas to lead the volatile compounds into a residual gas analyser equipped with a quadrupole mass spectrometer. The analysis was performed following the H₂S-specific signals at m/z 33 (HS⁺) and at m/z 34 (H₂S⁺) in real time, directly on the sample without laborious and expensive pre-treatments and with short response times (<6 s). Calibration with a standard mixture of 1000 ppm of H₂S in nitrogen allows semi-quantitative H₂S detection. The sensitivity and rapidity of the method were evaluated by quenching the release of sulphur compounds with commercial odour-suppressing agents. Upon addition of 0.1% of additive in two minutes, the H₂S signal drops about 80% in two minutes, confirming the good response of the method, even with a very complex matrix.