Conventionally and digitally fabricated removable complete dentures: manufacturing accuracy, fracture resistance and...

Conventionally and digitally manufactured removable complete dentures with different dentition forms were examined for manufacturing accuracy (trueness, precision), fracture forces under torsional loading and subsequent repairability.

A total of 90 mandibular prostheses were manufactured. Ten were made using the injection molding technique and finished with prefabricated teeth. 40 bases each, were manufactured subtractively and additively. Digitally the prosthesis' dental arch was divided either into two quadrants or three sextants, or kept as full arch. Afterwards, ten additive and subtractive bases were finished with prefabricated teeth and ten of each with milled quadrants, sextants and full arches. After manufacturing, all specimens were rescanned for accuracy comparisons using the Root Mean Square (RMS). Lastly, all specimens were tested to failure under torsional loading.

Conventionally manufactured dentures showed the greatest deviation in accuracy. The type of base manufacturing did not determine the fracture resistance of the prostheses. The dentition form had a significant influence. While prefabricated teeth (86.01 ± 19.76 N) and quadrants (77.89 ± 9.58 N) showed a low fracture resistance, sextants (139.12 ± 21.41 N) and full arches (141.05 ± 17.14 N) achieved the highest fracture forces. Subtractive bases with prefabricated teeth or quadrants were assessed to be repairable, digital dentures with full arch were assessed as not repairable.

The presented testing set-up is suitable to determine the fracture behavior of dentures rather than of standards. With the possibility of digital design and individual manufacturing, dentures' mechanical stability can be significantly increased, especially with suitable dentition forms.