Related Experiment Video
Updated: Jun 18, 2025

Measuring the Densities of Aqueous Glasses at Cryogenic Temperatures
Published on: June 28, 2017
Temperature dependence of spatial nanoheterogeneities of shear modulus in supercooled glycerol
1Institute of Automation and Electrometry of the Russian Academy of Sciences, 1 Koptyug Ave., Novosibirsk 630090, Russia.
Abstract:
The boson peak in the terahertz vibrational spectrum carries information about nano-heterogeneities in the shear modulus in glass formers. Its evolution upon heating or cooling in a supercooled liquid state may shed light on the temperature dependence of heterogeneities. For this purpose, an analysis of the light scattering spectra of supercooled glycerol in the spectral range of the boson peak and fast relaxation was carried out and the parameters of the boson peak in the temperature range 180-330 K were determined. The temperature dependent frequency of the boson peak was then expressed in terms of the mean-square amplitude of the shear modulus fluctuations. This was done using the heterogeneous elasticity theory in combination with the perturbation theory on small fluctuations and Ioffe-Regel criterion for transverse vibrations in glass formers. The contribution of structural relaxation effects to phonon damping becomes significant with increasing temperature. It is shown here that structural relaxation largely determines the temperature dependence of the mean-square fluctuations of the shear modulus at high temperatures. By solving the inverse problem, the temperature dependence of shear modulus fluctuations was obtained. It shows a rapid decrease above ∼250 K with a linear extrapolation going to zero at the so-called Arrhenius temperature TA = 350 K. Comparison with literature data on the Landau-Placzek ratio shows that they have a similar temperature dependence at T < TA, which is explained by the appearance of nanometer scale spatial heterogeneities below TA. This is confirmed by the temperature dependence of the amplitude of the boson peak.
More Related Videos
11:38Combining Microfluidics and Microrheology to Determine Rheological Properties of Soft Matter during Repeated Phase Transitions
Published on: April 19, 2018
09:46Protocol for Measuring the Thermal Properties of a Supercooled Synthetic Sand-water-gas-methane Hydrate Sample
Published on: March 21, 2016
Related Concept Videos
Problem Solving on Stress and Strain
Temperature Dependent Deformation
Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...
Phase Transitions: Melting and Freezing
Freezing Point Depression and Boiling Point Elevation
The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...
Effects of Temperature on Free Energy