Fabrication of granular three-dimensional graphene oxide/UiO-66 adsorbent for high uranium adsorption: Density...

This study presents a thorough investigation of the novel application of graphene oxide (GO) modified with melamine formaldehyde to fabricate granular three-dimensional GO (3D-GO), followed by the introduction of UiO-66 doping (3D-GO/U) for high uranium (U) adsorption. The U(VI) adsorption isotherms revealed that 3D-GO/U-10 with 10 % UiO-66 incorporation exhibited an impressive adsorption capacity of 375.5 mg g^-1 and remained high U(VI) sorption performance in wide pH range. The introduction of UiO-66 to 3D-GO (3D-GO/U-10) led to the deagglomeration of the UiO-66 particles. The in situ surface-enhanced-Raman-spectroscopy-analysis and density-functional-theory simulations showed the symmetric metal center site Zr-O₂ on UiO-66 was discovered to exhibit the highest adsorption energy (-3.21 eV) for U(VI) species due to the electrons transfer from the oxygen atom to U(VI) drives the covalent bonding between the symmetric metal center sites Zr-O₂ and U(VI) on 3D-GO/U-10. The 3D-GO/U-10 was regenerated using a 0.1 M Na₂CO₃/0.01 M H₂O₂ solution and achieved up to 89.7 % U(VI) removal in the 5^th cycle. The continuous flow column experiments results revealed 3D-GO/U-10 can regenerate and maintain a U(VI) removal capacity of ∼76 % for up to 4 cycles column experiments. Therefore, 3D-GO/U-10 exhibits great potential for removing U(VI) from water bodies.