Related Experiment Video
Updated: Jun 18, 2025

Tactile Semiautomatic Passive-Finger Angle Stimulator TSPAS
Published on: July 30, 2020
Task-dependent contribution to edge-based versus region-based texture perception
Elena Gheorghiu1, Cassandra Diggiss2, Frederick A A Kingdom2
1Department of Psychology, University of Stirling, Stirling, FK9 4LA, Scotland, UK. elena.gheorghiu@stir.ac.uk.
Abstract:
Texture segregation studies indicate that some types of textures are processed by edge-based and others by region-based mechanisms. However, studies employing nominally edge-based textures have found evidence for region-based processing mechanisms when the task was to detect rather than segregate the textures. Here we investigate directly whether the nature of the task determines if region-based or edge-based mechanisms are involved in texture perception. Stimuli consisted of randomly positioned Gabor micropattern texture arrays with five types of modulation: orientation modulation, orientation variance modulation, luminance modulation, contrast modulation and contrast variance modulation (CVM). There were four modulation frequencies: 0.1, 0.2, 0.4 and 0.8 cpd. Each modulation type was defined by three types of waveforms: sinewave (SN) with its smooth variations, square-wave (SQ) and cusp-wave (CS) with its sharp texture edges. The CS waveform was constructed by removing a sinewave from an equal amplitude square-wave. Participants performed two tasks: detection in which participants selected which of two stimuli contained the modulation and discrimination in which participants indicated which of two textures had a different modulation orientation. Our results indicate that threshold amplitudes in the detection task followed the ordering SQ < SN < CS across all spatial frequencies, consistent with detection being mediated by the overall energy in the stimulus and hence region based. With the discrimination task at low texture spatial frequencies and with CVM textures at all spatial frequencies the order was CS ≤ SQ with both < SN, consistent with being edge-based. We modeled the data by estimating the spatial frequency of a Difference of Gaussian filter that gave the largest peak amplitude response to the data. We found that the peak amplitude was lower for detection than discrimination across all texture types except for the CVM texture. We conclude that task requirements are critical to whether edges or regions underpin texture processing.
More Related Videos
07:12Development of a Gaze-Contingent Display Framework Designed for Perceptual and Oculomotor Research with Simulated Central Vision Loss
Published on: April 11, 2025
13:00Measuring Attention and Visual Processing Speed by Model-based Analysis of Temporal-order Judgments
Published on: January 23, 2017
Related Concept Videos
Association Areas of the Cortex
Prefrontal Association Area: This area is located in the frontal lobe and is involved in planning, decision-making, and moderating social behavior. It connects with primary motor areas,...
Somatosensation
Perception
Bottom-up processing begins at the sensory level, where receptors detect external environmental stimuli. These could include the tactile sensation of...
Motor and Sensory Areas of the Cortex
Motor Areas
The motor areas located in the frontal lobe are central to controlling voluntary movements. This region is further subdivided into the primary motor cortex and the premotor cortex....
Depth Perception and Spatial Vision
Factors Affecting Perception
An illustrative example of a perceptual set is the scenario where an airline pilot told...