Related Experiment Video
Updated: May 3, 2026
Author Spotlight: Three-Dimensional Cephalometric Landmark Annotation Demonstration on Human Cone Beam Computed Tomography Scans
Published on: September 8, 2023
Cone-Beam Computed Tomography Study of Incisive Canal and Maxillary Central Incisors in Dravidian Population
Abirami Selvaraj1, Aravind Kumar Subramanian1
1Orthodontics and Dentofacial Orthopedics, Saveetha Dental College and Hospitals, Saveetha Institute of Medical and Technical Sciences, Saveetha University, Chennai, IND.
Introduction:
En-masse maxillary anterior retraction is necessary to attain an esthetic profile in Angle's class I bimaxillary dentoalveolar protrusion and Angle's class II division 1 malocclusion. The objective of this study was to evaluate configurational relationships between maxillary incisors and incisive canal in Angle's class I bialveolar protrusion and Angle's class II division 1 malocclusion by cone-beam computed tomography (CBCT).
Methods:
A total of 108 adult CBCT scans of 54-skeletal class I bialveolar protrusion and 54-skeletal class II division 1 malocclusions were retrospectively analyzed. Angles between palatal plane and axis of maxillary alveolar border (θ1), incisive canal (θ2), and maxillary right central incisor (θ3) were measured in relation to the midsagittal plane. Linear measurements such as incisive canal width (IC-IC), medial inter-root distance (Rm-Rm), posterior inter-root distance (Rp-Rp), anteroposterior distance from Rm to tangent of right central incisor (11 Rm-Cat), and left central incisor (21 Rm-Cat) corresponding to three vertical levels (L1, L2, and L3) were assessed in axial cross-sectional plane. Association among angular measurements was examined by Spearman correlation coefficient analysis. Mann-Whitney U test compared variables of linear measurements at three vertical levels.
Results:
Estimated distance from incisor root to incisive canal was 5-6 mm in both groups slightly influenced by skeletal class and vertical levels but not gender. Mann-Whitney test demonstrated significant differences between groups at three vertical levels (p<0.05). Only θ2 revealed a significant difference (p<0.05) between malocclusions compared to θ1 and θ3. The angular measurements for both malocclusions were positively correlated (p<0.05).
Conclusion:
Sagittal root-canal cortical plate distance varied significantly in both malocclusions (5-6 mm). Inter-root distance (Rp-Rp) was greater than incisive canal width (IC-IC) at all three vertical levels indicating a reduced possibility of canal invasion after maximum retraction at posterior levels.
Related Concept Videos
01:10Computed Tomography
The technique was invented in the 1970s and is based on the principle that as X-rays pass through the body, they are absorbed or reflected at different levels. In the technique, a patient lies on a motorized platform while a computerized axial tomography (CAT) scanner rotates...
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
01:26Assessment of the Mouth
Mouth Inspection
The inspection begins with visually examining the mouth for symmetry, color, and size.
01:28Imaging Studies for Cardiovascular System V: CT
01:25Imaging Studies for Cardiovascular System VI: Calcium -Scoring CT
01:27Imaging Studies III: Computed Tomography