Phosphorus attenuation and mobilization in sand filters treating onsite wastewater
Mian Wang1, Fanjian Zeng1, Siwei Chen1
1Department of Civil Engineering, College of Engineering and Applied Sciences, Stony Brook University, Stony Brook, NY, 11794, USA; New York State Center for Clean Water Technology, Stony Brook University, Stony Brook, NY, 11794, USA.
Abstract:
The effectiveness of phosphorus (P) removal by sand filters is limited during septic tank effluent (STE) treatment. The elevated effluent P concentrations pose threats to drinking water quality and contribute to eutrophication. The concern of P leaching from sand filters is further exacerbated by the increased frequency of flooding and natural precipitation due to climate change. This study aimed to understand P attenuation and leaching dynamics, as well as the removal mechanisms in sand filters treating STE, offering insights into the design and implementation of P removal/recovery modules to onsite wastewater treatment systems. P attenuation and leaching during STE treatment and rainfall were studied in bench-scale columns (new vs. aged sand). At standard STE loading (1.2 gallon d-1 ft-2), 24-32% removal of total phosphorus (TP) was achieved, while increased P removal efficiency (35-53%) was observed at low loading (0.6 gallon d-1 ft-2) with influent containing 10.3-20.0 mg P L-1. Complete breakthroughs were observed in both aged (12-70 days) and new columns (27-73 days) at test hydraulic loadings. The maximum TP attenuation level was 20.6-45.3 mg P kg-1 and 25.3-33.0 mg P kg-1, in aged and new sand columns, respectively. When simulated rain was applied (15-60 mm h-1), 80-97% of the attenuated P leached out and the leaching dynamics were impacted by rainfall duration rather than the intensity. The highest concentrations of TP (15.6-15.9 mg L-1) were leached out from both columns within the first 2-6 h. Orthophosphate was the dominant P species in treated effluent (83-84%) and leachate (69-88%), demonstrating its significance as the major P form in the discharge. In addition, aged sand (>5 years) accumulated higher levels of Mg, Al, Ca, and Fe, thus enhancing the P attenuation level during STE treatment. Collectively, this study underscored the importance of frequent field monitoring for reliable long-term P removal estimates.
